APR 2018
CMT-330TC Three-Knife Trimmer
3-3
3. Operator's Guide
3.2 Power up
To switch the power on to the CMT-330TC, turn
the main power switch clockwise.
Figure 3-2. Power Switch
When the power on, the startup screen should
appear as follows:
Figure 3-3. Start Up Screen
The startup screen lists the detected installed
peripherals (infeed/outfeed options). If the list is
not correct, re-check the infeed and outfeed
communication connections as described in
Section 2. Installation Guide.
Press the green start button (Figure 3-3) to ini-
tialize the machine (or follow the instructions on
the screen if there is a different message).
Figure 3-4. Start Button
Once the machine is initialized, the Run screen
will appear and display the installed infeed and
outfeed accessories (Figure 3-5).
Figure 3-5. Run Screen
The trimmer is now ready to trim books to the di-
mensions shown on the right side of the screen.
Later sections describe how to program and op-
erate the CMT-330TC.
3.3 Status Light
The status light (Figure 3-4) informs the operator
of the current operational state of the trimmer
and/or accessories. The possible status light in-
dications are as follows:
Solid Green
– The trimmer is running and is
ready to trim books or is trimming books.
Flashing Yellow
– The trimmer is not running.
Action must be taken to start the trimmer. For
example, the outfeed device needs to be emp-
tied or the start button needs to be pressed.
Flashing Red
– There is an error in the trimmer
and/or accessories that needs to be resolved
before the trimmer will be able to run.
Summary of Contents for CMT-330TC
Page 4: ...APR 2018 CMT 330TC Three Knife Trimmer iv Introduction Notes...
Page 28: ...APR 2018 CMT 330TC Three Knife Trimmer 1 24 1 Introduction NOTES...
Page 60: ...APR 2018 CMT 330TC Three Knife Trimmer 3 12 3 Operator s Guide NOTES...
Page 72: ...APR 2018 CMT 330TC Three Knife Trimmer 4 12 4 Routine Tasks NOTES...
