APR 2018
CMT-330TC Three-Knife Trimmer
3-10
3. Operator's Guide
3.6.4 Color Settings
Figure 3-19. Color Settings
This tab is used to change the colors of the dis-
play to
the operator’s preferences. There are
three areas that can be set: The color bar, back-
ground color, and dialog box colors. Use the
slider bars to select the colors as desired. Press
the dot next to the appropriate text to change to
the next selection.
3.6.5 Options & Updates
Figure 3-20. Options & Updates
The Options & Updates tab is used to set certain
factory settings and also to perform software up-
dates. This screen is not accessible unless the
code
6125
is entered into the Enable Tabs Code
input box on the Service Info tab.
Note: Settings on this screen must be set
correctly, or else damage to machine could
result! Use caution when editing!
Machine Size/Model
– Specifies which model of
trimmer the TC controller is installed on. This is
set at the factory and should only need to be set
once.
Press to Clear Programmed Jobs
– This will
wipe out all the machine memory containing pro-
grammed jobs. All jobs stored on the machine
will be lost.
Press to Load Factory Default Parameters
–
This can be useful when it is necessary to return
to factory settings.
Load Software and Program Flash
– Used to
update the CMT-330TC software. The latest
software version as well as step-by-step updat-
ing instructions can be found at:
www.challengemachinery.com/software
Load Params from USB
– Pressing this button
loads parameter settings that were stored previ-
ously using “Save Params to USB”. This is use-
ful if parameter settings are ever lost due to a
catastrophic failure.
Save Params to USB
– Pressing this button
saves all current parameter settings to a USB
drive. This should be done as a precautionary
measure prior to a software upgrade in the event
of a catastrophic failure.
3.6.6 Hydraulic/Air
Figure 3-21. Hydraulic/Air
This tab is used to set various hydraulic and
pneumatic settings for the trimmer. This screen
is not accessible unless the code
6125
is en-
tered into the Enable Tabs Code input box on
the Service Info tab.
Note: Settings on this screen must be set
correctly, or else damage to machine could
result! Use caution when editing.
Knife Cushion Value
– Sets the amount of
“cushion” that the hydraulic system exhibits near
the bottom of a cut cycle.
Minimum Jog Pressure
– Sets the minimum
pressure that the trimmer will use for the left
hand side jogger. Press the button below the
slider to test this value on very thin books.
CAUTION
Caution: When testing the jog pressure, make
sure to place a book in the jogger area first!
Failure to do so may result in damage to the jog-
ger cylinder!
Summary of Contents for CMT-330TC
Page 4: ...APR 2018 CMT 330TC Three Knife Trimmer iv Introduction Notes...
Page 28: ...APR 2018 CMT 330TC Three Knife Trimmer 1 24 1 Introduction NOTES...
Page 60: ...APR 2018 CMT 330TC Three Knife Trimmer 3 12 3 Operator s Guide NOTES...
Page 72: ...APR 2018 CMT 330TC Three Knife Trimmer 4 12 4 Routine Tasks NOTES...
