24
S
AFETY
S
TANDARDS FOR
M
AINTENANCE
Before starting the maintenance and inspection procedures, always perform the following operations:
Always wear adequate clothing and accident-prevention equipment during the various phases of maintenance.
In particular:
- Overalls
with
snug-fitting
cuffs
- Goggles/safety
glasses
- Gloves
- Helmet
- Dust
mask
- Safety
Harness
- Safety
shoes
Always use equipment that is in good condition
Have on hand a portable lamp to light the areas under maintenance.
Identify system cut-off switches;
Cut off power to the electrical system before performing any operation near or on moving mechanical parts
or before performing any operation on powered parts of the system.
Use Lock Out/Tag Out procedures to lock the cut-off switch in the open position using a padlock.
Make certain that the system is not repowered while maintenance work is in progress.
NEVER operate directly on control breaker
NEVER lubricate parts while they are moving
Post signs reading “DO NOT PERFORM ANY OPERATIONS, Machine Undergoing Maintenance”
During maintenance or replacement of hydraulic system components,
Always prevent any foreign bodies, even very small ones, from entering the circuit as this could lead to
malfunction.
Vent hydraulic pressure before loosening the connections
MACHINE
OUT
OF
SERVICE
machine
undergoing
maintenance
Summary of Contents for SX14
