-
9-
SCOOTER INITIAL SET UP
Please follow the below steps in case you receive your Challenger XL
scooter not assembled by your dealer.
1)
Remove the battery cover.
2)
Place two group 24 batteries onto the battery pan and secure them.
3)
Join the battery terminals with the receptacle from the controller box.
4)
Join all cables with the same labeling, except the wire for turning lights.
5)
Lift up the rear shroud and connect the wire for the turning lights.
6)
Pull seat swivel lever. Put the seat on the top of the seat post and lock the
seat in position by releasing the lever.
7)
Adjust the height of the seat with the bolt under the seat.
Figure 2
