UPHILL HINGES
MODELS 2190P AND 2195P
INSTALLATION
The uphill hinges will be perpendicular to the road surface when properly
installed. There will be an imaginary line running through the center of both
hinges (Figure 1).
1. Stand the gate in the open position (Figure 2). Open hinges 90 degrees
with the yoke extensions fl at against the post and the gate extensions
fl at against the end rails of the gate (Figure 2). Tack weld the yoke
extensions to the gate post.
DO NOT tack weld the gate extensions.
NOTE:
It may be necessary to elevate the far end of the gate to allow for
the weight of the suspended gate after installation
.
2. Tack weld the gate extensions to the gate with the gate in the closed
position (Figure 3).
3. Verify the gate opens and closes as desired. Adjust as necessary
to achieve proper gate movement and alignment. Securely weld
extensions to the post and gate after gate movement and alignment
have been confi rmed.
4. Remove any excess material form the extensions. Grind all sharp
edges. Paint all bare metal and welds as necessary. Lubricate both
hinges prior to use. One pump of a high quality, multi-purpose grease
every 3 months should be suffi cient under normal operating conditions.
More frequent maintenance is necessary under severe operating
conditions. Do not over lubricate. Gate will be slightly canted when gate
is in the open position (Figure 4).
LiftMaster.com
LIMITED LIFETIME WARRANTY
LiftMaster
®
warrants that the LiftMaster Gate Hinges shall be free from all
defects in materials and workmanship for the lifetime of the original gate it
is installed on, by the original end user, under normal use and service, and
when installed and maintained according to manufacturer specifi cations and
instructions. LiftMaster’s obligation under this warranty is specifi cally limited
to repairing or replacing, at its option, any defective part during the warranty
period. This warranty shall not apply to any part which has been altered,
damaged, improperly installed or maintained, or repaired by any person not
expressly authorized by LiftMaster in writing to perform the repair. The warranty
will not apply to parts which have been damaged by accident or improper use,
nor to non-defect damage. All other warranties, including but not limited to any
warranty of merchantability or fi tness for any particular purpose, or otherwise
expressed or implied, are hereby disclaimed, except as specifi cally stated above.
LiftMaster shall in no event be liable either for incidental or consequential
damages or for any special damages of further loss, which may arise in
connection with any claim. However, if LiftMaster is held liable, whether directly
or indirectly, for any loss or damage arising under this limited warranty or
otherwise, regardless of the cause or origin, LiftMaster’s maximum liability shall
not in any case exceed the purchase price of the individual product or products,
refund of which shall be the complete and exclusive remedy against LiftMaster.
This warranty gives the owner specifi c legal rights, and owner may have other
rights, which vary from state to state. Some states do not allow limitations or
exclusions or implied warranties for incidental or consequential damages so the
foregoing limitations or exclusions may not apply.
Figure 1
Figure 2
Figure 3
Figure 4
90
°
