26
THE REMOTE CONTROL BATTERY
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fi re, explosion or chemical burn:
• Replace ONLY with 3V2016 coin batteries.
• DO NOT recharge, disassemble, heat above 100° C
(212° F) or incinerate.
3-BUTTON REMOTE CONTROLS
Additional buttons on the remote control can be
programmed to operate up to 3 devices such as additional
garage door openers, light controls, gate operators or
access control systems.
Press and hold the button down until the door or gate
starts to move. The remote control will operate from up
to 3 car lengths away on typical installations. Installations
and conditions vary, contact an installing dealer for more
information.
Using the Remote Control
NOTICE: To comply with FCC and or Industry Canada rules (IC),
adjustment or modifications of this receiver and/or transmitter are
prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards for Home or office use.
Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
The LED(s) on your remote control will stop fl ashing when
the battery is low and needs to be replaced. To replace
battery, open the case as shown. Insert battery positive
side up (+). Replace the battery with only 3V2016 coin cell
batteries. Dispose of old battery properly.
Remove the two screws
and open the case.
3V2016
TO CONTROL THE OPENER LIGHTS
Additional buttons on the remote control can be
programmed to operate the garage door opener lights
without opening the door.
1.
With the door closed
, press and hold the remote button
that you want to control the light.
2. Press and hold the Light button on the
Smart Control Panel
®
.
3. Press and hold the Lock button on the
Smart Control Panel
®
.
4. After the opener lights fl ash, release all buttons.
Test by pressing the remote push button. The opener
lights should turn on or off but the door should not move.
