3-BUTTON REMOTE CONTROLS
MODELS 890MAX, 893MAX, AND 895MAX
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate or play with remote controls.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted and there
are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
LED
LED
Locate the Program button on
the remote control.
Locate the Learn
button on the garage
door opener.
NOTE:
Your garage door
opener may look different.
OR
OR
Learn
LED
Learn
LED
Learn
LED
Green
or
Red/Orange
Purple
Yellow
Program Button
2
3
Press and release the remote control button
you want to use...
4
To exit programming mode, press
any remote control button
except
the button that was just programmed.
Install the visor clip (not
applicable for Model 890MAX).
6
The garage door opener
will activate.
To test, press the programmed button on
the remote control...
1
Press and release the
Learn button on the
garage door opener.
Within 30 seconds...
The Learn LED will light.
Check to see if the garage
door opener light bulb
blinks.
If not, wait for the remote
control LED to light solid
then
slowly
press and
release the remote
control button again.
Repeat
until the
light bulb blinks.
DO NOT
press the
button after the light
bulb blinks.
5
To enter programming mode, press the Program button
until the LED on the
front
of the remote control turns on.
Safety Pin or
Paper Clip
Visor Clip
MODEL 893MAX
MODEL 890MAX
PREPARE
PROGRAMMING THE REMOTE CONTROL
893MAX
890MAX
MODEL 895MAX
895MAX
LEDs
890MAX
895MAX
893MAX
Can be used as a replacement remote control for 80
Series, 970 Series, and 370 Series LiftMaster remote
controls.
Compatible with 315 MHz or 390 MHz garage door
openers manufactured after January 1, 1993. Make
sure the garage door opener has a working light bulb
because it is a programming indicator.
For use with gate operators, commercial door
operators, or other products that are 315 MHz or 390
MHz and have a Learn button. Refer to your product
manual for the location of the Learn button.
