2
INSTALLATION
IMPORTANT NOTE:
The Garage Power Station can be installed on the
ceiling or wall. The Garage Power Station can be mounted to a single
ceiling joist or wall stud or across two ceiling joists or wall studs.
1. Select a mounting location for the Garage Power Station within 6
feet of an electrical outlet.
2. Use a stud finder to locate the joists and studs where the Garage
Power Station will be mounted. Mark the center of each joist or
stud.
NOTE:
Mounting holes for the Garage Power Station are 16"
apart. If the distance between each joist or stud is 24" on center
the Garage Power Station will need to be mounted to a single joist
or stud.
3. Mark the mounting holes 16" apart and drill 3/16" pilot holes in the
center of the stud(s) or joist(s).
NOTE:
Ensure mounting holes are
level.
4. Remove the screws from the task light covers and pry the task
light covers from the Garage Power Station cover with a small
flathead screwdriver.
NOTE:
If you do not have a 6" socket
extension, you will need to remove the Garage Power Station
cover to access the mounting holes by removing the 4 screws
that secure the cover to the mounting plate.
TOOLS
• Tape
measure
• Stud
finder
• Pencil or marker
• Drill
• 3/16" Drill bit
• #3 Phillips screwdriver
• 7/16" socket wrench
• 6" socket extension (optional)
• Small flathead screwdriver
5. Place a washer and small rubber isolator on each lag screw. Insert
each lag screw through the mounting holes of the mounting plate.
6. Place a large rubber isolator on each of the lag screws behind the
mounting plate.
7. Position the Garage Power Station over the stud/joist with the tip
of each lag screw inserted in a pilot hole.
8. Tighten each lag screw with a 7/16" socket wrench with extension.
9. Insert light bulb (not provided) into the light socket and turn it
clockwise to secure the light bulb. Slide the light bulb into the
retainer ring located on the task light cover. (Figure 1)
10. Reinstall the task light covers by inserting the bottom tabs first,
then press into place. Secure with the screws.
11. Plug the Garage Power Station into the electrical outlet.
NOTE:
Excess power cord may be wrapped around the back of the
mounting plate.
Task Light Cover (Back)
Light Bulb
Retainer Ring
Light Socket
GU10 Halogen
Light Bulb
FIGURE 1
Lag Screw
Washer
Small Rubber
Isolator
Garage Power
Station Mounting
Plate
Mounting
Hole
Task Light Cover (Back)
Wall Studs
or Ceiling Joists
Pilot Holes
Mounting Hole
Mounting Hole
Large Rubber
Isolator
Task Light Cover (Back)
