3
OPERATION
Pull the work light assembly down to a position where the reel prevents
the cord from being retracted and release to activate the Garage Power
Station. The task lights will turn on and power will be supplied to the
outlet in the work light. Power will be supplied to the compressor and
will run for 3 – 5 seconds to fill air hose to cutoff pressure.
WORK LIGHT
Turn on the work light by pressing the on/off button on the work light
assembly. Press the on/off button again to turn the work light off.
INFLATOR
To inflate vehicle or bicycle tire:
1. Pull the work light assembly near the tire to be inflated and at a
point where the cord does not automatically retract when released.
2. Pull the hose out of the retainer on the side of the work light
assembly.
3. Press the lever on the quick connect locking tire chuck valve and
push over the end of the tire valve.
4. Release the lever to lock onto the valve. The tire will immediately
start to inflate.
5. Monitor the pressure gauge on the back of the work light.
6. Press the lever on the tire chuck and pull off the tire valve when
desired pressure is reached. The inflator will then turn off.
7. Replace the hose in the retainer on the side of the work light
assembly.
8. Pull and release the work light assembly so it automatically returns
to the fully retracted position and power to the Garage Power
Station is turned off.
To inflate an object with the inflation accessory:
1. Select the appropriate inflation accessory.
2. Insert the inflation accessory into the desired object to be inflated.
3. Pull the hose out of the retainer on the side of the work light
assembly.
4. Press the lever on the quick connect locking tire chuck valve and
push over the end of the inflation accessory.
5. Release the lever to lock onto the inflation accessory. The object
will immediately start to inflate.
6. Monitor the pressure gauge on the back of the work light assembly.
7. Pull the inflation accessory out of object when desired pressure is
reached.
8. Press lever on the tire chuck and pull the inflation accessory out of
tire chuck. The inflator will then turn off.
9. Replace the hose in the retainer on the side of the work light
assembly.
10. Pull and release the work light assembly so it automatically returns
to the fully retracted position and power to the Garage Power
Station is turned off.
HOOK
Pull the hook out of top of the work light assembly and hang at desired
location. Before storing, return the hook to the original position making
sure it snaps into place.
TASK LIGHTS
To turn on the task lights, pull the work light assembly down slightly to
a position where it does not retract automatically and release. To turn
off the task lights, pull on the work light assembly to the fully retracted
position.
BALL STOP
The ball stop acts as a stop for the retractable work light assembly and
activates a switch to turn off the air compressor. The ball stop can be
adjusted by loosening the four screws on the ball stop, sliding the ball
stop along the cable, then tightening the screws at the desired position.
Inflator
Hose
Hook
Task Lights
Work Light
On/Off
Button
Pressure
Gauge
Outlet
WORK LIGHT ASSEMBLY
Retainer
Ball Stop
Inflator
