37
Push Button
LIGHT Button
PIN
OR
Operation
Remote Control and Keyless Entry
PRE-PROGRAMMED REMOTE CONTROL INCLUDED, NO NEED TO
PROGRAM THE REMOTE.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote
controls are NOT compatible.
PROGRAM USING THE MULTI-FUNCTION CONTROL PANEL
1. Press the LEARN button on the door control to enter programming mode. The command LED
will flash once.
2. Press the LEARN button again, the command LED will flash once again.
3.
Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless
entry
keypad. Then press the ENTER button.
PROGRAM USING THE PUSH BUTTON DOOR CONTROL
1. Press and hold the light button and the push button until the push button LED
begins to blink.
2.
Remote control:
Press the button on the remote control that you wish to
operate your garage door.
Keyless entry:
Enter a 4-digit personal identification number (PIN) of your
choice on the keyless entry keypad. Then press the ENTER button.
1-2
3
OR
PIN
LEARN LED
LEARN
Button
“click”
“click”
PROGRAM USING THE GARAGE DOOR OPENER LEARN BUTTON
1. Locate the LEARN Button.
2. Press and immediately release the LEARN button. The LEARN LED will glow steady for 30
seconds. Within 30 seconds...
3.
Remote Control:
Press and hold the button on the remote control that you wish to use.
Key-
less Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless
entry keypad. Then press and hold the ENTER button.
Releasethebutton when thegaragedoor opener lights blinkor twoclicks areheard.
HomeLink
®
If your vehicle is equipped with HomeLink
®
, a Compatibility Bridge™ (not included) may be
necessary for certain vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed. Repeat the steps for programming additional remote controls or keyless entry devices.
If programming is unsuccessful, follow the steps to program using the garage door opener LEARN
button.
