26
HIG
H
NORM
HIG
H
NORM
M
C
M
C
Setting Security Mode (High) or (Normal):
Setting Output Duration (M) or (C):
P4
P2
Changing security from High to Normal.
Default Position
Default Position
Changing output duration from Momentary to Constant.
The receiver is factory set at
HIGH
security mode. To verify, refer
to the label next to jumper P4. (See illustration below)
The Receiver can be used with up to
15
rolling code remotes or
pins in
HIGH
security mode.
Alternately, it can be used with up to
31
of any type remote in
NORMAL
security mode,
including any
combination of rolling code, billion code, or dip switch remotes.
When changing from
NORMAL
to
HIGH
security mode,
all
previous remote control codes must be erased.
See next page to
erase and reprogram remote controls that are being used.
The receiver is factory set at (
M
) Momentary. To verify, refer to
the label next to jumper P2. (See illustration above)
For commercial applications, the receiver can be set to either (
C
)
constant or (
M
) momentary closure.
With the jumper in the (
M
) momentary position, the
contacts will
close for 1/4 second regardless of the length of remote control
transmission.
With the jumper in (
C
) constant position, the
contacts will stay
closed as long as the remote control continues transmitting.
Push and
HOLD
remote button to open or close gate.
3 1 5 M H Z 2 4 V D C R A D I O R E C E I V E R P R O G R A M M I N G
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed
NEVER permit anyone to cross path of moving gate or door.
To AVOID damaging receiver, disconnect receiver’s power
BEFORE changing jumpers.
To reduce the risk of SERIOUS INJURY or DEATH, the use
of CONSTANT OPERATION on residential operators
is PROHIBITED.
WARNING
CAUTION
WARNING
