27
3 1 5 M H Z 2 4 V D C R A D I O R E C E I V E R P R O G R A M M I N G
Programming Radio Receiver:
1.
Press and release the “
Learn
” button on the
receiver. The learn indicator light will glow steadily for
30 seconds.
2.
Within 30 seconds, press and hold the button on the hand-held remote. The
operator will now operate when the push button on the remote control is pressed.
Repeat Steps
1
and
2
for each remote control that will be used.
Erase ALL Remote Control Codes:
Press and hold the “
Learn
” button on the receiver panel until the indicator light turns
off (about 6 seconds). All previous codes are now erased. Reprogram each remote you
wish to use.
IMPORTANT:
Hand Held Remote
NOT
Included.
NOTE:
Receiver wiring on Surge
Suppressor Terminal Connections page.
Disconnect the second receiver when
using a master/second setup.
NOTICE:
To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE
N
O OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Learn
Button
Optional 315 MHz Hand Held Remotes - See Accessories
