44
1.
Owner and Installer must read all warnings and safety precautions. (Pages 4-7)
2.
Make sure control box is securely mounted. (Page 13)
3.
Operator arm must be
securely
and correctly fastened to mounting brackets. (Page 12)
4.
Operator arm must be
level
in both directions. (Page 11)
5.
When gate is pulled,
No
slippage of operator arm should occur. (Page 13)
6.
Control box should be grounded to an earth ground rod within 3 feet. (Page 18)
7.
Verify that both the battery and plug-in transformer are connected properly and
Property Owner
knows how to
disconnect
all
power to the operator with battery plug and plug-in transformer. (Page 20)
8.
Verify that the gate opens and closes as needed. (Page 26)
9.
When gate hits object during operation, it
must
stop or reverse direction. (Page 28)
10.
Know how to operate the emergency manual release with the key.
(Page 33)
11.
Make sure that any pinch point or potential entrapment are guarded by means of safety devices or like. (Pages 6 and 24)
12.
Warning placards need to be permanently mounted on
both
sides of gate. (Page 4)
13.
Test all additional equipment connected to operator.
14.
Make sure all wire connections are
securely
fastened.
15.
Review typical maintenance on operator. (Page 31)
16.
Schedule periodic maintenance on operator by qualified service technician.
17.
Inquire about Manufacturers “operator warranty”. (Warranty Card Included with operator)
18.
Inquire about
separate
“installation warranty” with installer.
Installer Company Name, Address and Phone Number
Installation Checklist
