PROGRAMMING
Before You Begin
• The
BLACK
button is used for
LIMIT LEARN
and
TIMER TO CLOSE
settings.
• The
PURPLE
button is used for
RADIO LEARN
and
FORCE LEARN
.
• The large button on the 3-button remote control is
pre-programmed to activate your gate operator. It is
required to program your travel limits.
• The
YELLOW
LED provides learning mode feedback.
PROGRAMMING GATE TRAVEL (LIMIT LEARN)
SETTING THE OPEN POSITION
a. With the gate in the closed position, press and hold
the
BLACK
button until the
YELLOW
LED begins
to blink (approximately 7 seconds), then release.
b. Push and hold the
BLACK
button until the gate
reaches the desired
OPEN
position (not to exceed
100°). If required, push the
PURPLE
button to jog
the gate back toward the
CLOSE
position.
c. Once you have the gate in the desired
OPEN
position, press the large remote control button.
This will set the
OPEN
position and immediately
begins closing the gate.
d. When the gate begins to close, press and release
either the
BLACK
or
PURPLE
button. This will stop
the gate.
SETTING THE CLOSE POSITION
a. Press and hold the
PURPLE
button until the gate
reaches the desired closed position If required, use
the
BLACK
button to jog the gate back towards the
OPEN
position.
b. Once the gate is in the desired closed position,
press the large remote control button. This will set
the
CLOSE
position and the gate will immediately
begin to open.
LEARNING THE FORCE
Make certain that the gate path is free from any
obstructions while learning the force. Use the
programmed remote control and run the gate to the
fully closed position. After reaching the fully closed
position now run the gate to the fully open position.
This will complete the force learn and the
YELLOW
LED will stop blinking and turn off.
LEARN / CLOSE
MODE / OPEN
GATE
FORCE
MAX
MIN
RESET
R17
S1
S2
C38
C98
U2
C42
D16
Purple Button
Yellow LED
Black Button
Force
Adjustment
Pot
1
2
3
Allow gate to open fully. The limits are now set. The
YELLOW
LED will be blinking. Continue with step 3.
21
Programming
