3LIDE 'ATE %NTRAPMENT 0ROTECTION
Secure Side
Public Side
Gap between vertical
bars MUST be less
than 2-1/4" (57 mm)
Interior posts,
non-pinch rollers (2x)
Place warning signs
on both sides of the
gate in clear view
Take a photograph of the complete installation site for your records
Any gap larger than 2-1/4" (57 mm) between
gate and fixed objects MUST be protected.
Install edge sensors where gap between post
and gate creates a draw in zone.
Pedestrian gate located near the slide gate.
Make sure a separate pedestirian entrance is
available and the path is clearly designated.
6' (1.8 m)
minimum
Photoelectric sensor
(close direction)
Photoelectric sensor
(close direction)
Photoelectric sensor (open direction)
Photoelectric sensor (open direction)
Left hand
gate opening
Edge sensor
Edge sensor
Edge sensor
Earth ground
Illustration is for example only; your site may have
additional entrapment zones which MUST be protected.
3WING 'ATE %NTRAPMENT 0ROTECTION
Cross Section
Pedestrian gate located near
the swing gate. Make sure a
separate pedestirian entrance
is available and the path is
clearly designated.
Secure Side
Public Side
Edge
sensor
Entrapment
zone
Curb
Curb
Reflector for
photoelectric
sensor
Photoelectric
sensor
Photoelectric sensor
(public side)
Photoelectric sensor
(public side)
Earth ground
Mount access control devices at
least 6' (1.8 m) beyond the gate
Take a photograph of the complete
installation site for your records
Place the warning signs on both
sides of the gate in clear view
ENTRA
PM
ENT
ZONE
Illustration is for example only; your site may have
additional entrapment zones which MUST be protected.
