,IMIT AND &ORCE !DJUSTMENT
4O REDUCE THE RISK OF 3%6%2% ).*529 OR $%!4(
z
7ITHOUT A PROPERLY INSTALLED SAFETY REVERSAL SYSTEM PERSONS
PARTICULARLY SMALL CHILDREN COULD BE 3%2)/53,9 ).*52%$ OR
+),,%$ BY A MOVING GATE
z
4OO MUCH FORCE ON GATE WILL INTERFERE WITH PROPER OPERATION OF SAFETY
REVERSAL SYSTEM
z
.%6%2 INCREASE FORCE BEYOND MINIMUM AMOUNT REQUIRED TO MOVE
GATE
z
.%6%2 USE FORCE ADJUSTMENTS TO COMPENSATE FOR A BINDING OR STICKING
GATE
z
)F ONE CONTROL FORCE OR TRAVEL LIMITS IS ADJUSTED THE OTHER CONTROL
MAY ALSO NEED ADJUSTMENT
z
!FTER !.9 ADJUSTMENTS ARE MADE THE SAFETY REVERSAL SYSTEM -534 BE
TESTED 'ATE -534 REVERSE ON CONTACT WITH AN OBJECT
3LIDE GATE OPERATORS WITH THE NEW CONTROL BOARD REQUIRE A
MINIMUM OF TWO
EXTERNAL MONITORED ENTRAPMENT PROTECTION DEVICES TO FUNCTION ONE IN THE OPEN
DIRECTION AND ONE IN THE CLOSE DIRECTION
)NTRODUCTION
9OUR OPERATOR IS DESIGNED WITH ELECTRONIC CONTROLS TO MAKE TRAVEL LIMIT
AND FORCE ADJUSTMENTS EASY 4HE ADJUSTMENTS ALLOW YOU TO PROGRAM
WHERE THE GATE WILL STOP IN THE OPEN AND CLOSE POSITION 4HE ELECTRONIC
CONTROLS SENSE THE AMOUNT OF FORCE REQUIRED TO OPEN AND CLOSE THE GATE
4HE FORCE IS ADJUSTED AUTOMATICALLY WHEN YOU PROGRAM THE LIMITS BUT
SHOULD BE FINE TUNED USING THE 2%6%23!, &/2#% DIAL ON THE CONTROL
BOARD REFER TO
&INE 4UNE THE &ORCE
SECTION TO COMPENSATE FOR
ENVIRONMENTAL CHANGES 4HE LIMIT SETUP ,%$S LOCATED NEXT TO THE 3%4
/0%. AND 3%4 #,/3% BUTTONS INDICATE THE STATUS OF THE LIMITS REFER TO
THE TABLE TO THE RIGHT
4HE LIMITS CAN BE SET USING THE CONTROL BOARD BELOW OR A REMOTE CONTROL
REFER TO
,IMIT 3ETUP WITH A 2EMOTE #ONTROL
IN THE !PPENDIX 3ETTING THE
LIMITS WITH A REMOTE CONTROL REQUIRES A BUTTON REMOTE CONTROL
PROGRAMMED TO /0%. #,/3% AND 34/0
./4% 4HE 4%34 BUTTONS ON THE CONTROL BOARD WILL NOT WORK UNTIL THE
LIMITS HAVE BEEN SET AND THE REQUIRED ENTRAPMENT PROTECTION DEVICES ARE
INSTALLED
)NITIAL ,IMITS AND &ORCE !DJUSTMENT
&OR DUAL GATE APPLICATIONS THE LIMITS WILL HAVE TO BE SET FOR EACH
OPERATOR 4HE GATE -534 BE ATTACHED TO THE OPERATOR BEFORE SETTING
THE LIMITS AND FORCE
&OR SLIDE GATE APPLICATIONS THE OPEN LIMIT AND CLOSED LIMIT -534 BE SET
AT LEAST FOUR FEET APART
0RESS AND RELEASE THE 3%4 /0%. AND 3%4 #,/3% BUTTONS
SIMULTANEOUSLY TO ENTER LIMIT SETTING MODE
0RESS AND HOLD ONE OF THE -/6% '!4% BUTTONS TO MOVE THE GATE TO
THE OPEN OR CLOSE LIMIT
0RESS AND RELEASE THE 3%4 #,/3% OR 3%4 /0%. BUTTON DEPENDING
ON WHICH LIMIT IS BEING SET
0RESS AND HOLD ONE OF THE -/6% '!4% BUTTON TO MOVE THE GATE TO
THE OTHER LIMIT
0RESS AND RELEASE THE 3%4 #,/3% OR 3%4 /0%. BUTTON DEPENDING
ON WHICH LIMIT IS BEING SET
#YCLE THE GATE OPEN AND CLOSE 4HIS AUTOMATICALLY SETS THE FORCE
7HEN LIMITS ARE SET PROPERLY THE OPERATOR WILL AUTOMATICALLY EXIT LIMIT
SETTING MODE
,)-)4 3%450 ,%$3
3%4
/0%.
,%$
3%4
#,/3%
,%$
/0%2!4/2
-/$%
%80,!.!4)/.
/&&
/&&
./2-!, -/$%
,IMITS ARE SET
",).+).'
",).+).'
,)-)4 3%44).'
-/$%
,IMITS ARE NOT SET
",).+).'
/.
,)-)4 3%44).'
-/$%
/PEN LIMIT IS NOT SET
/.
",).+).'
,)-)4 3%44).'
-/$%
#LOSE LIMIT IS NOT SET
/.
/.
,)-)4 3%44).'
-/$%
,IMITS ARE SET
2
6
3
1
Swing gate
Slide gate
HCTDCUL
HCTDCUL
4
5
