0ROGRAMMING
2EMOTE #ONTROLS .OT 0ROVIDED
! TOTAL OF 3ECURITY
REMOTE CONTROLS OR +07 KEYPADS AND
KEYLESS ENTRIES 0). FOR EACH KEYLESS ENTRY CAN BE PROGRAMMED TO THE
OPERATOR 7HEN PROGRAMMING A THIRD KEYLESS ENTRY TO THE OPERATOR THE
FIRST KEYLESS ENTRY WILL BE ERASED TO ALLOW THE THIRD KEYLESS ENTRY TO BE
PROGRAMMED 7HEN THE OPERATORS MEMORY IS FULL IT WILL EXIT THE
PROGRAMMING MODE AND THE REMOTE CONTROL WILL NOT BE PROGRAMMED 4HE
MEMORY WILL NEED TO BE ERASED BEFORE PROGRAMMING ANY ADDITIONAL
REMOTE CONTROLS
./4% )F INSTALLING AN ,- TO EXTEND THE RANGE OF THE
REMOTE CONTROLS $/ ./4 STRAIGHTEN THE ANTENNA
4HERE ARE DIFFERENT OPTIONS FOR PROGRAMMING THE REMOTE CONTROL DEPENDING ON HOW YOU WOULD LIKE THE REMOTE CONTROL TO FUNCTION #HOOSE A
PROGRAMMING OPTION
/04)/.
$%3#2)04)/.
02/'2!--).' 34%03
3INGLE BUTTON AS /0%.
ONLY
0ROGRAM A SINGLE BUTTON ON THE REMOTE
CONTROL FOR OPEN ONLY 4HE 4IMERTO#LOSE
CAN BE SET TO CLOSE THE GATE
0RESS AND RELEASE THE ,%!2. BUTTON OPERATOR WILL BEEP AND GREEN
8-)44%2 ,%$ WILL LIGHT
./4% 4HE OPERATOR WILL TIME OUT OF
PROGRAMMING MODE AFTER SECONDS
0RESS THE /0%. BUTTON
0RESS THE REMOTE CONTROL BUTTON THAT YOU WOULD LIKE TO PROGRAM
3INGLE BUTTON 3"# AS
/0%. #,/3% AND 34/0
0ROGRAM ONE REMOTE CONTROL BUTTON AS AN
OPEN CLOSE AND STOP
0RESS AND RELEASE THE ,%!2. BUTTON OPERATOR WILL BEEP AND GREEN
8-)44%2 ,%$ WILL LIGHT
./4% 4HE OPERATOR WILL TIME OUT OF
PROGRAMMING MODE AFTER SECONDS
0RESS THE REMOTE CONTROL BUTTON THAT YOU WOULD LIKE TO PROGRAM
4HREE SEPARATE BUTTONS AS
/0%. #,/3% AND 34/0
0ROGRAM EACH REMOTE CONTROL BUTTON AS AN
OPEN CLOSE AND STOP
0RESS AND RELEASE THE ,%!2. BUTTON OPERATOR WILL BEEP AND GREEN
8-)44%2 ,%$ WILL LIGHT
./4% 4HE OPERATOR WILL TIME OUT OF
PROGRAMMING MODE AFTER SECONDS
0RESS THE /0%. #,/3% OR 34/0 BUTTON DEPENDING ON THE DESIRED
FUNCTION
0RESS THE REMOTE CONTROL BUTTON THAT YOU WOULD LIKE TO PROGRAM
4HE OPERATOR WILL AUTOMATICALLY EXIT LEARN MODE OPERATOR WILL BEEP AND GREEN 8-)44%2 ,%$ WILL GO OUT IF PROGRAMMING IS SUCCESSFUL 4O PROGRAM
ADDITIONAL 3ECURITY
REMOTE CONTROLS OR REMOTE CONTROL BUTTONS REPEAT THE PROGRAMMING STEPS ABOVE
./4)#% 4HIS DEVICE COMPLIES WITH 0ART OF THE &## RULES AND )NDUSTRY #ANADAS LICENSEEXEMPT 233S /PERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE AND THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION
!NY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT
4HIS DEVICE MUST BE INSTALLED TO ENSURE A MINIMUM CM IN DISTANCE IS MAINTAINED BETWEEN USERSBYSTANDERS AND DEVICE
4HIS DEVICE HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A #LASS " DIGITAL DEVICE PURSUANT TO PART OF THE &## RULES AND )NDUSTRY #ANADA )#%3 STANDARD 4HESE LIMITS ARE DESIGNED
TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION 4HIS EQUIPMENT GENERATES USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND IF NOT INSTALLED AND USED
IN ACCORDANCE WITH THE INSTRUCTIONS MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS (OWEVER THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION )F THIS
EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON THE USER IS ENCOURAGED TO TRY TO CORRECT THE
INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES
2EORIENT OR RELOCATE THE RECEIVING ANTENNA
)NCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER
#ONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED
#ONSULT THE DEALER OR AN EXPERIENCED RADIO46 TECHNICIAN FOR HELP
