3
LOOSEN BEARING COVER SCREWS
1. Locate the four bearing cover screws that secure the
Passpoint assembly onto the arm.
2. Loosen the bearing cover screws by turning them three times
counterclockwise.
WARNING
•
Do not remove these screws.
•
Do not loosen any other drive train flange screws.
•
Removing these parts will require that the arm be entirely
replaced.
REMOVE THE BUSHING RETAINER FROM THE ARM NOSE
1. Using a wide flathead screwdriver or T25 torque wrench,
remove the two bushing retainer mounting screws that
secure the bushing retainer to the arm.
2. Remove the bushing retainer and place in a clean location
with the corresponding screws.
Bushing Retainer Mounting Screws
Bushing
Retainer
Bearing Cover Screws
Passpoint Assembly
