17
INSTALLATION
WIRELESS DUAL GATES
INSTALL A SECOND OPERATOR ARM AND CONTROL
BOX
Install a second operator arm and control box by following installation
steps 1-7.
TO ACTIVATE THE WIRELESS FEATURE
1. Choose a control box to be the network primary operator. All wireless
accessories will need to be programmed to the primary control board.
NOTE:
We recommend that all accessories and board configurations
are set on the primary control board.
2. Press and release the LEARN button on the primary control board.
The green XMITTER LED will light.
NOTE:
The operator will time out
of programming mode after 180 seconds.
3. Press and release the LEARN button again on the primary control
board. The yellow NETWORK LED will light.
4. Press and release the OPEN test button to assign this operator as
network primary.
5. Press and release the LEARN button on the secondary control board.
The green XMITTER LED will light.
6. Press and release the LEARN button again on the secondary control
board. The yellow NETWORK LED will light.
7. Press and release the CLOSE test button to assign this operator as
network secondary.
Both operators will beep and the yellow NETWORK LEDs will turn off
indicating programming is successful.
TO DEACTIVATE THE WIRELESS FEATURE:
1. Press and release the LEARN button on either control board. The
green XMITTER LED will light.
2. Press and release the LEARN button again on the same control board.
The yellow NETWORK LED will light.
3. Press and hold the LEARN button for 5 seconds. The yellow
NETWORK LED will blink (operator will beep) then turn off indicating
successful deactivation.
Repeat the steps for the other control board.
STEP 8
DUAL GATES ONLY
There are two options for dual gate communication: wired or wireless. Follow the directions according to your application. Do not use wired and
wireless communication simultaneously.
Wired dual gate applications will have a longer battery standby time than wireless applications. Wireless
dual gates will require the installation of two control boxes, one for each operator arm.
Moving Gate Can Cause
Inju
ry or Death
KEEP CLEAR!
Gate may move at
any
time without prior warning.
Do not let children operate the gate or
play in the gate area.
This entrance is for vehicles only
Pedestrians must use separate entrance
Moving Gate Can Cause
Injury or Death
KEEP CLEAR!
Gate may move at any
time without prior wa
rning.
Do not let chi
ldren operate the gate or
play in the gate area.
This entrance is for vehicles only
Ped
estria
ns must use separate entrance
MAX
OPEN
CLOSE
ST
OP
TEST
BUTTONS
RSAL
RCE
XMITTER
NETWORK
LEARN
T
BUT
REVERSAL
FORCE
XMITTER
NETWORK