12
Drywall Anchors
Insulated
Staples
Screw 6ABx1-1/2"
Lighted Door Control Button
HARDWARE SHOWN ACTUAL SIZE
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
Be sure power is not connected BEFORE installing door
•
control.
Connect ONLY to 24 VOLT low voltage wires.
•
To prevent possible SERIOUS INJURY or DEATH from a closing
garage door:
Install door control within sight of garage door, out of reach
•
of children at a minimum height of 5 feet (1.5 m), and away
from ALL moving parts of door.
NEVER permit children to operate or play with door control
•
push buttons or remote control transmitters.
Activate door ONLY when it can be seen clearly, is properly
•
adjusted, and there are no obstructions to door travel.
ALWAYS keep garage door in sight until completely closed.
•
NEVER permit anyone to cross path of closing garage door.
Lighted
Door Control
Button
2-Conductor
Bell Wire
KG
KG
1
3
9
7
5
1
3
9
7
5
2
3
1
Opener
Terminal
Screws
Antenna
Back Panel
of Opener
Lighted
Door Control
Terminal Screws
2-Conductor
Bell Wire
WHT
RED
-2
-1
INSTALLATION STEP 6
Install the Door Control
Locate the door control within sight of the door at a minimum
height of 5 feet (1.5 m) where small children cannot reach, and
away from all moving parts of the door and door hardware.
Strip 7/16" (11 mm) of insulation from one end of the bell wire.
1.
Connect it to the two screw terminals on the back of the door
control by color: white wire to 2 and white/red wire to 1.
Fasten the Lighted Door Control Button securely with
2.
6ABx1-1/2" screws. If installing into drywall, drill 5/32" holes
and use the anchors provided.
Run the bell wire up the wall and across the ceiling to the
3.
opener. Use insulated staples to secure the wire in several
places. Be careful not to pierce the wire with a staple, creating a
short or open circuit.
Receiver terminal screws and the antenna are located on the
4.
back panel of the motor unit. Position the antenna wire as
shown.
Connect the bell wire by color to the opener terminal screws:
5.
white to 2 and white/red to 1.
Use tacks or staples to permanently attach the entrapment
6.
warning label to the wall near the door control, and the manual
release/safety reverse test in a prominent location on the inside
of the garage door.
NOTE:
DO NOT connect the power and operate the opener at this
time. The trolley will travel to the full open position, but will not
return to the close position until the sensor beam is connected
and properly aligned. See Safety Reversing Sensor instructions
beginning on page 15.
TO PREVENT THE MOTOR PROTECTOR FROM
TRIPPING, DO NOT EXCEED 8 DOOR
OPERATIONS PER HOUR.
FASTEN LABEL ADJACENT TO DOOR
POUR ÉVITER QUE LE DISPOSITIF DE
PROTECTION DU MOTEUR NE SE
DÉCLENCHE, NE PAS FAIRE FONCTIONNER
LA PORTE PLUS DE 8 FOIS PAR HEURE.
FIXER L'ÉTIQUETTE PRÈS DE LA PORTE.
132A2112A
WARNING
Keep Door in Sight at all Times When Door is Moving
Moving Door Can Cause
Serious Injury or Death
Keep Clear! Door May Move at any Time
Without Prior Warning
Do Not Let Children Operate the Door or Play
in the Door Area
Outside Keylock Accessory Connections
To opener terminal screws: White to 2 and white/red to 1.
