Chamberlain LiftMaster Professional SL585, Manual

Min = 0 sec

Max = 180 sec

16

TIMER TO CLOSE ENABLE

This switch enables the auto close timer. The timer to close 
feature works in conjunction with the potentiometer located on 
the board.

SLIDE/SWING

This switch selects slide or swing gate operation, in order to 
optimize gate behavior for specific application.

SL = Slide • SW = Swing

R

T

                    L

T

SW                   SL

1     2     3    4

ON

SA
VE

TTC

ON

S1

1     2     3    4

ON

SA
VE

TTC

ON

S1

R

T

                    L

T

SW                   SL

APEMs

ON

CLED                    PH

OPED                   PH

1     2     3    4

WA

R

N

MAG

ON

S2

ON

CLED                    PH

OPED                   PH

1     2     3    4

WA

R

N

MAG

ON

S2

ON

CLED                    PH

OPED                   PH

1     2     3    4

WA

R

N

MAG

ON

S2

ON

CLED                    PH

OPED                   PH

1     2     3    4

WA

R

N

MAG

ON

S2

1     2     3    4

ON

SA
VE

TTC

ON

S1

1     2     3    4

ON

SA
VE

TTC

ON

S1

R

T

                    L

T

SW                   SL

R

T

                    L

T

SW                   SL

PROGRAM SETTINGS (DIP SWITCH S1)

NOTE: 

For all S1, S2 and S4 switch settings to take effect, the Save Mode switch must be set to the off position.

PROGRAM SETTINGS (DIP SWITCH S2)

TIMER TO CLOSE

1     2     3    4

ON

SA
VE

TTC

ON

S1

1     2     3    4

ON

SA
VE

TTC

ON

S1

R

T

                    L

T

SW                   SL

R

T

                    L

T

SW                   SL

1     2     3    4

ON

SA
VE

TTC

ON

S1

1     2     3    4

ON

SA
VE

TTC

ON

S1

R

T

                    L

T

SW                   SL

R

T

                    L

T

SW                   SL

(Factory Default)

TIMER TO CLOSE 

ENABLED

SWING GATE

SLIDE GATE

TIMER TO CLOSE

DISABLED

(Factory Default)

LEFT HAND

RIGHT HAND

(Factory Default)

LOCKED

UNLOCKED

(Factory Default)

MAGLOCK ENABLED

MAGLOCK DISABLED

(Factory Default)

WARNING ENABLED

WARNING DISABLED

(Factory Default)

RIGHT/LEFT OPERATION

This switch selects the gate opening direction, to the left or to 
the right. Right/Left operation is determined from the inside of 
fence looking out.

“SAVE” SWITCH

This switch stores all settings into memory and locks out changes.

NOTE: 

For any programming changes to take effect this switch 

must be in OFF position. When switch is ON, no settings can be 
changed.

MAGLOCK ENABLE

This switch enables the Maglock feature. On an open command 
there will be a half second delay after the maglock relay is 
released before the motor starts. 

WARNING ENABLE

This switch enables the gate “in motion” alarm feature. The 
alarm will beep 3 seconds prior to movement and throughout 
movement.