Chamberlain LiftMaster Professional SL585, Manual

19

ACCESSORY WIRING

REMOTELY MOUNTED STOP/RESET CONTROL WIRING

•  This control will function as a Stop/Reset command and is to be 

wired within line of sight of the gate.

•  Wire Stop/Reset control station to terminals 3 and 5 on the 

control box on the operator. 

Make sure that all Stop/Reset 

controls are wired in series.

Terminals 6 & 5 (Com) - Soft Open

These terminals are intended for use as a general open control. 
Accessories that may be wired to this input include: Telephone 
Entry Systems, Radio Receiver (Commercial Applications), Exit 
Loop Detector, Keypads, 7-Day Timer. 

NOTE: 

Will not override a 

double entrapment (signalled by the gate stopped and entrapment 
alarm on).

1

2

3

4

5

6

7

8

9 10 11 12 13 14

3

6

9

#

2

5

8

0

1

7

Soft Open

1

2

3

1 2 3 4 5

6 7

Control
Conduit

Control
Conduit

Stop/Reset
Button

Stop/Reset
Button

NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of 
this receiver and/or remote control are prohibited, except for changing the code setting or 
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and (2) this device 
must accept any interference received, including interference that may cause undesired operation.

FIGURE 3

PROGRAMMING THE REMOTE TO THE RECEIVER

1.  Pry open the front panel of receiver case with a coin or a 

screwdriver. Re-connect power to operator (Figure 3).

2.  Press and release the "learn" button on the receiver. The learn 

indicator light will glow steadily for 30 seconds.

3.  Within 30 seconds, press and hold the button on the hand-held 

remote that you wish to operate your gate operator.

The opener will now operate when the push button on either the 
receiver or the remote control is pressed.

Repeat Steps 2 and 3 for each remote control that will be used to 
operate the gate operator.

TO ERASE ALL REMOTE CONTROL CODES 

Press and hold the “learn” button on the receiver panel until the 
indicator light turns off (about 6 seconds). All remote codes are 
now erased. Then follow the steps above to reprogram each 
remote control.

FIGURE 2

M

M

Jumper

Output 
Duration 
Terminals

Jumper

Output 
Duration 
Terminals

MOMENTARY 
OPERATION

CONSTANT 
OPERATION

24V

12V

HIGH

NORM

C

P2

M

Output Duration 
Terminals

Power Supply 
Jumper

Security Mode 

OPEN RECEIVER

OPENING  RECEIVER

Indicator Light

Learn Button

Connect 
Antenna