4
Set-Up with Existing Network
Gate Access Panel (GAPLM) as Primary
Access Control Unit
Enter Master PIN Number on Keypad:
5
6
Enter Master PIN Number on GAPLM:
Then:
Then:
“BEEP” “BEEP”
Door Access Intercom (DAILM) as
Primary Access Control Unit
Enter Master PIN Number on Keypad:
5
6
Press and release the Learn button on the DAILM.
Keypad will beep twice indicating programming is
successful.
Then:
Keypad as Primary Access Control Unit
Step 1:
On Secondary Keypad enter Master PIN
Number:
Step 2:
Then:
5
6
NOTE:
To switch a Secondary Keypad to a Main
Keypad, enter the Master PIN Number followed by
“57”.
Step 3:
On Main Keypad enter Master PIN Number:
Step 4:
Then:
0
5
NOTE:
If a siren noise is heard the programming has
failed. Repeat process.
Pro
g
rammin
g
Secondary Keypads to
additional Receivers (GCU or
ULTRX900R)
A Secondary Keypad defaults to activating
Receiver #2 when a PIN Number is entered on that
Keypad.
To activate Receiver #3:
Enter Master PIN Number on Keypad:
5
8
Then:
To activate Receiver #4:
Enter Master PIN Number on Keypad:
5
9
Then:
0
5
Pre-Installed Liftmaster
Receiver
Step 1:
Pry open the front
panel of the receiver case
with a coin or a screwdriver.
Step 2:
Press and release
the Learn button on the
receiver. The Indicator Light will
light for 30 seconds indicating that
receiver is in Learn Mode.
Step 3:
Within 30 seconds enter Master PIN Number
on Keypad.
Step 4:
Press “1”.
Repeat Steps 2-4 for each remote, or control device
that will be used to access the Liftmaster door or gate
operator.
Pro
g
ram
Erase All Control Codes
Press and hold the Learn button on the receiver until
the Indicator Light turns off indicating that the receiver
memory is clear (about 6 seconds).
12V
HIGH
NORM
C
P2
M
Indicator Light
Learn Button
