16
NOTE: The transmitter(s) and wireless wall button supplied with
your opener are preprogrammed by the factory.
If you purchase additional transmitters, the garage door opener must
be programmed to accept the new transmitter code.
Program the Receiver to Match Additional Transmitter Codes:
Using the yellow “LEARN” Button
1.Press and Hold the button on the hand-held transmitter or wall button
that you wish to use (1).
2.Press and release the yellow “LEARN” button on the opener (2).
3.Release the transmitter button when the opener light flashes. It has
learnt the code. If you release the transmitter button before the
opener light flashes, the opener has not learned the code.
Now the opener will operate when the transmitter button is
pressed.
To Erase all Transmitter Codes
1.Press and Hold the yellow “LEARN” button on the opener until the
indicator LED goes ON, and continue holding for approx. 6 seconds,
until the indicator LED goes out.
1.Release the button, all codes are now erased.
Wireless Keypad E840M
To set the keyless entry PIN:
1.Locate the yellow “LEARN” button on the garage door opener.
2.Press and release the yellow “LEARN” button. The LED indicator
light will glow steadily.
3.Enter a 4-digit personal identification number (PIN) of your choice
on the keypad.
4.Press and hold the ENTER button. Check to see if the opener light
flashes. Release the ENTER button after the light flashes.
To change an existing keyless entry PIN:
1.Enter the existing programmed PIN that you want to change.
2.Press and hold the # button until the courtesy light flashes twice.
3.Enter the new 4-digit PIN of your choice, then press the ENTER
button. The light will flash once.
4.To test, enter the new PIN, then press the ENTER button. The
garage door opener will activate.
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should
enter or leave garage while door is in motion. Do not allow children to operate push button(s) or
transmitter(s). Do not allow children to play near the door.
Yellow “Learn” Button
1
2
2
3
4
3
Press and release
the yellow
learn button
Enter a 4-digit
PIN of your
choice
? ? ? ?
_ _ _ _
Press and hold
the enter button
Opener light flashes
After the lights
flash release the
ENTER button
1
Locate
the yellow
learn button
26
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
