60 s
120 s
180 s
O
–
2
white
MT600 / MT1000
3
grey
white wires
white/black
wires
2
1
3
Connecting the Protector System
Locate the terminals on the back of the unit. Strip all
wires back about 10mm then twist the two white wires
and the two white/black wires together. Trim the twisted
wires to approximately 6mm. Use a small screwdriver or
pen to hold down the spring terminals, insert the
white/black wires into the grey terminal (3), then
terminate the white (only) wires into the white terminal
(2).
NOTE: Optional connections: Connect the white
(only) wires and white/black wires into separate
terminals on the back of the unit as illustrated
above. This may be required if larger diameter cable
extensions have been used to extend wiring.
Setting Auto-close (MT1000 ONLY)
NOTE:The Protector System
TM
MUST be installed to
enable this feature.
Ensure that the trim pot is set to 0s when terminating
cables. Beams must be uninterrupted for up to five
minutes after turning on to initialise. (The Trim pot
should not be adjusted during this 5 minute initialising
period)
.
NOTE: After the beams are initialised, they are
constantly monitored, and if removed the opener
will not close until the beams are re-installed.
INSTALL THE PROTECTOR SYSTEM™ (IR BEAMS)
SAFETY FIRST!
Whilst Chamberlain have engineered safety features into
your garage door opener, we urge you to consider fitting
IR Beams. In many countries these devices are
compulsory to assist in the prevention of serious injury or
property damage. For your own peace of mind and the
safety of others please install this inexpensive safety
device.
26
1
3
2
B
2
3
6
6
-?
50 s
180 s
O
Chamberlain recommends an annual service by an
authorized dealer.
See owner’s manual for all programming instructions.
If you require an owner’s manual: in Australia, phone
toll free 1800 873 696; in New Zealand, phone toll free
0800 653 667 or visit our website
www.chamberlainanz.com
For Service Call:
Installation Date:
Dealer Name:
Door may operate unexpectedly, therefore do not allow anything to stay in the path of the door.
11
Install this accessory for all installations on Canopy
doors, One-Piece Door with Horizontal and Vertical
Track, doors over 2.5m and when the closing force
as measured on the bottom of the door is over 400N
(40kg).
After opener has been installed and adjusted, the
Protector System™ accessory can be installed.
Instructions are included with this accessory.
The Protector System™ provides an additional
measure of safety against a small child being
caught under a garage door. It uses an invisible beam
which, when broken by an obstruction, causes a closing
door to open and prevents an open door from closing
and is strongly recommended for homeowners with
young children.
NOTE: The opener will automatically detect the
Protector System
TM
when it is installed and
operating for 5 minutes (during this time the beams
must remain unobstructed). The opener will not
close unless the sensors are aligned.
Auto close is NOT recommended for
households with young children.
