1
2
4
3
7
LOCK
LIGHT
5
LOCK
LIGHT
6
LOCK
LIGHT
23
Program your Keyless Entry
(optional)
Activate the opener only when door is in
full view, free of obstruction and properly
adjusted. No one should enter or leave
garage while door is in motion. Do not
allow children to operate push button(s)
or remote(s). Do not allow children to play
near the door.
NOTE:
Your new Keyless Entry must be
programmed to operate your garage door
opener.
Program the Receiver to Match Additional
Remote Control Code
Using the orange “LEARN” Button:
1. Press and release the orange “learn”
button (1) on opener. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad (2), then press
and hold the ENTER button.
3. Release the button when the opener light
blinks (3). It has learned the code. If the
light bulb is not installed, two clicks will be
heard.
NOTE:
This method requires two people if
the Keyless Entry is already mounted outside
the garage.
Using the Multi-Function Door Control:
4. Enter a four digit personal identification
number (PIN) of your choice on the
keypad, then press and hold ENTER.
5. While holding the ENTER button, press
and hold the LIGHT button on the
Multi-Function Door Control.
6. Continue holding the ENTER and LIGHT
buttons while you press the push bar on
the Multi-Function Door Control (all three
buttons are held).
7. Release buttons when the opener light
blinks. It has learned the code. If the light
bulb is not installed, two clicks will be
heard.
LOCK
LIGHT
LOCK
LIGHT
24
Optional Motion Detecting Control Panel
Press the push bar (1) to open or close the door. Press again to stop the
door.
Light feature
Press the light button (2) to turn the opener light on or off. It will not control
the opener lights when the door is in motion. If you turn it on and then
activate the opener, the light will remain on for 2 1/2 minutes. Press again to
turn it off sooner. The 2 1/2 minute interval can be changed to 1-1/2, 3-1/2
or 4-1/2 minutes as follows: Press and hold the Lock button (3) until the
light blinks(about 10 seconds). A single blink indicates that the timer is reset
to 1-1/2 minutes. Repeat the procedure and the light will blink twice,
resetting the timer to 2-1/2 minutes. Repeat again for 3-1/2 minute interval,
etc., up to a maximum of four blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held remote controls.
However, the door will open and close from the Door Control, the Outside
Keylock and the Keyless Entry Accessories.
To activate, press and hold the Lock button (3) for 2 seconds. The push bar
light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds. The push
bar light will stop flashing.
The Lock feature will also turn off whenever the “LEARN” button on the
opener panel is activated.
14
1
2
3
PIR Motion
detector.
If activated the PIR
motion detector will
turn your courtesy
light on for 2 1/2
minutes
