21
ADJUSTMENT STEP 2
Setting the Force
The Orange LEARN button is located on the left
panel of the opener. The force setting measures the
amount of force required to open and close the door.
1. Locate the orange learn button on the left panel of the
opener (Figure 1).
2. Push the orange button twice to enter the opener into
Force Adjustment Mode (Figure 2). The LED (Indicator
Light) will flash quickly.
Activate the door by pressing the Remote Control button
or the Push Bar on your LCD Motion Detecting Control
(Figure 3) to open and close the door until the Indicator
Light turns off. The LED (Indicator Light) will stop flashing
when the force required to open and close your door has
been learnt.
The door must travel through a complete cycle, UP and
DOWN, in order for the force to be set properly. If the
opener cannot open and close your door fully, inspect
your door to ensure that it is balanced properly and is not
sticking or binding. Refer page 2, “Preparing your garage
door.”
Black
Button
Orange
Button
Push Orange button
twice to enter
Force Adjustment Mode
Indicator
Light
Figure 1
• Too much force on garage door will interfere with proper
operation of safety reversal system.
• NEVER use force adjustments to compensate for a binding or
sticking garage door.
• After ANY adjustments are made, the safety reversal system
MUST be tested. Door MUST reverse on contact with 40mm high
object laid flat on floor.
Figure 2
or
Figure 3
