FIG. 1-5
Attach emergency release cord & tag
.
9
3. Attach boom to power head.
•
Place boom in front of power head with boom strap
at opposite end.
•
Support door end of boom (boom strap) at about
same height as power head.
–
Check if magnet is in place
(Fig. 1-3 inset)
. Insert
carriage slide into boom
(Fig. 1-3)
.
(Carriage slide
is long straight piece attached to chain.)
–
Pull boom toward you as you feed chain into it.
(Fig. 1-3)
. When the end of the boom is within
about 2 chain links of the power head, you can
then push it the rest of the way. (It is a snug fit.)
–
Securely fasten with 2 bolts (9) and nuts (10)
(Fig. 1-4)
.
OPEN GREEN PARTS BAG
FIG. 1-3
Slip carriage slide into boom
.
FIG. 1-4
Attach boom to power head
.
magnet
4. Attach emergency release cord, knob and tag.
•
Tie overhand knot in 1 end of cord. Tighten knot.
(FIG. 1-5 inset A)
.
–
Slip opposite (no knot) end through knob.
–
Slip through hole in emergency release lever
(Fig. 1-5)
.
–
Tie overhand knot in this end also. Tighten knot.
5. Attach emergency release tag
.
•
Attach to hole in emergency release using metal
twist tie on tag.
(Fig. 1-5 inset B)
.
[10]
[9]
carriage slide
wire
twist
tie
overhand knot
B
A
1/4"-20
1/4"-20 x 5/8"
