4
Carton Inventory
Your garage door opener is packaged with all parts illustrated below. If anything is missing, carefully check the packing
material. Hardware for assembly and installation is also listed below.
INSTALLATION HARDWARE
Insulated Staples (10)
Dry Wall Anchors (2)
Rope
Handle
CABLE TENSION SENSOR
INSTALLATION HARDWARE
Lag Screw 1/4” x 1” (5)
SAFETY REVERSING SENSOR
INSTALLATION HARDWARE
Carriage Bolt 1/4”-20x1/2” (2)
Wing Nut (2)
Insulated Staples (2)
SITE PREPARATIONS
It is imperative that the wall or mounting surface provide ade-
quate support for the operator.
NOTE: The plywood shipping base supplied with the unit
may be used for this purpose. Securely anchor the shipping
base to the wall then mount the operator securely to the
base.
This surface must:
a) Be rigid, to prevent play between operator and
door shaft.
b) Provide a level base.
c) Permit the operator to be fastened securely,
with the drive shaft parallel to the door shaft.
The safety and life of the operator will be adversely affected
if any of the above requirements are not met.
WARNING
CAUTION
WARNING
WARNING
Without a properly working safety reversal system,
persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door.
The gap between the bottom of the garage door and
the floor MUST NOT exceed 1/4”. Otherwise, the
safety reversal system may not work properly.
The floor or the garage door MUST be repaired to
eliminate the gap.
