32
Programming
Your hand-held remote control (model 950ESTD) has already been programmed to the door control (Motion-Detecting
Control Panel) at the factory. Below are instructions for programming
additional
remote controls, keypads, and myQ
®
enabled accessories to the door control.
PIN
?
?
?
?
REMOTE CONTROL
1. Press the control panel LEARN button twice, and
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
1. Press the control panel LEARN button twice, the red
learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keypad. Then press the ENTER
button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
MODEL 940ESTD KEYPAD
LEARN
Button
LEARN
Button
Model PILCEV - Remote Light Control
Light module can be synchronized with
the garage door opener light bulbs.
Model WSLCEV - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
LIGHT ACCESSORIES
1. Press the control panel
LEARN button twice, the red
learn LED will turn on.
2. Press the LEARN button on
the myQ
®
device.*
* myQ
®
accessories may be
programmed to the 828LM
Internet Gateway.
Command
LED (yellow)
Learn LED
(Red)