5
201102-01
Decorative
Screw
Fixture Top
TESTING AND ADJUSTMENTS
1. Turn on the circuit breaker and light
switch.
Note:
Sensor has a 1
1
/
2
minute warm up period
before it will detect motion. When first turned
on wait 1
1
/
2
minutes.
2. Set:
• ON-TIME switch to TEST
• SENSITIVITY to Mid (M) position
3. Walk through the coverage area noting where
you are when the lights turn on. In TEST mode,
light will stay on for 5 seconds after motion has
stopped and then turn off.
4. Increase or decrease the sensitivity as needed.
Too much sensitivity may cause false triggering
due to heat sources in the coverage area (see
Troubleshooting section).
5. Set the amount of ON-TIME you want the
light to stay on after motion is detected (1, 5,
or 10 minutes). The timer will reset as long
as there is motion present. Once motion has
stopped, the timer will time-out after the
selected amount of time.
Figure 5
9.1 m
(30 ft.)
1.8 m
(6 ft.)
Maximum
Maximum Range
Coverage Angle*
(Side View)
(Top View)
180°
TEST 1 5 10 MIN
ON-TIME
LO - M - HI
SENSITIVITY
