The Remote Control Batteries
The 3V2016 lithium batteries for the opener and LED lights
(marked “LED and Opener Battery”) should last 5 years. The
3V2450 lithium battery for the proximity lighting (marked
“Proximity Battery”) should last 1-2 years.
To replace the batteries, remove the two screws and open the
remote control housing. Push the battery out of the holder for
removal. Insert replacement batteries positive side up (+).
Dispose of old batteries properly.
Replace the batteries with only 3V2016 or 3V2450 coin cell
batteries.
CAUTION:
Do not bend spring contact. If bent, the proximity
sensor will not work.
©2007, Chamberlain Group Inc.
114A3566
All Rights Reserved
Proximity
Battery
LED and
Opener
Batteries
Spring
Contact
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FOR SERVICE, DIAL OUR TOLL FREE NUMBER:
1-800-528-9131
Replacement Parts
PART NO.
DESCRIPTION
QTY
10A19
3V2016 Lithium Battery: LED and Opener
2
10A33
3V2450 Lithium Battery: Proximity Switch
1
29C151
Visor Clip
1
Troubleshooting
Reduced proximity
sensing (does not
activate by touching
top of remote control)
Check if proximity lighting is disabled
by pressing a button.
Replace 3V2450 battery with same
type 3V2450 coin cell.
The Proximity Sensor may be
oversensitized. Sit remote control
undisturbed for 60 seconds on a
non-metallic surface. This allows the
sensor to recalibrate itself.
Dim LED lights
Replace two 3V2016 batteries with
same type 3V2016 coin cells.
No rapid LED blinking
after pressing a button
Replace two 3V2016 batteries with
same type 3V2016 coin cells.
PROBLEM
SOLUTION
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with
3V2016 or 3V2450
coin batteries.
• Do NOT recharge, disassemble, heat above 212°F (100°C) or
incinerate.
