9
ENGLISH
92251-1
ASSEMBLy
C
D
A
3) Install the Beam Cont’d.
4) Install the Cylinder and Wedge Cont’d.
4) Install the Cylinder and Wedge
1. Place the wedge on the beam between the cylinder
mounts and slide it forward into the rails. (A)
2. Remove the cylinder mounting plates. (A)
5) Install the Oil Filter
1. Remove the oil filter from the oil filter base.
2. Install the oil filter base onto the hydraulic oil tank.
The barb fitting should be oriented vertically and
once installed the oil filter should be oriented so that
it does not extend below the hydraulic oil tank.
3. Lightly lubricate the filter seal with oil.
4. Install the oil filter onto the oil filter base. Tighten ¾-1
turn once the oil filter seal contacts the oil filter base.
5. Install the hose retaining ring to the side of the
splitting beam.
3. Install the cylinder by sliding the pegs at the end
of the cylinder into the mounting slots on top of the
beam. Be sure to slide the cylinder all the way back
into the mounting slots. (B)
5. Hold the top of the beam by the cylinder mount and
carefully rotate the beam toward the tow bar.
6. Once the bracket on the bottom of the beam is aligned
with the tow bar, secure with pin and R-pin. (D)
The cylinder will support itself when slid all the way
back into the mounting slots.
NOTE
4. Secure the cylinder mounting plates with hardware
removed in step 2. (B)
5. Slide the wedge back toward the cylinder and align
the bolt hole in the wedge with the bolt hole in the
cylinder rod. (B)
6. Secure the wedge to the cylinder rod with an
M12x75 bolt and M12 nut. Lightly tighten the nut to
approximately 5 ft-lb. (B)
B
The cylinder rod may need to be rotated slightly
in order to properly align the the wedge. Insert a
screwdriver into the bolt hole in the cylinder rod
and slowly rotate as needed.
NOTE
3. Slowly lift the front of the tow bar to roll the frame
toward the beam and carefully align the pivot holes
on the bottom of the beam and the top of the
hydraulic oil tank.
4. Once aligned, secure the beam to the tank with hitch
pin and R-pin. (C)
