Champion Power Equipment 92251-1, Owner'S Manual

15

ENGLISH

92251-1

MAINTENANCE AND STORAGE

The owner/operator is responsible for all periodic 
maintenance.

Complete all scheduled maintenance in a timely manner. 
Correct any issue before operating the log splitter.

Improper maintenance will void your warranty.

For service or parts assistance, contact our help line 
at 

1-877-338-0999.

NOTE

Never operate a damaged or defective log splitter.

WARNING

WARNING

Oil Cont’d.

Air Filter

1.  Using your fingers, press and slide the top of the air 

filter housing to remove.

2.  Remove the plastic outer casing.
3.  Remove the foam element. 
4.  Wash in liquid detergent and water. Squeeze 

thoroughly dry in a clean cloth.

5.  Saturate in clean engine oil. 
6.  Squeeze in a clean, absorbent cloth to remove all 

excess oil.

7.  Place the filter in the assembly.
8.  Reattach the air filter cover.

Used oil is a hazardous waste product and must be 
disposed of properly. Do not discard with household 
waste. Check with your local authorities, service 
center, or dealer for safe disposal/recycling facilities.

WARNING

Engine Maintenance

To prevent accidental starting, remove and ground spark 
plug wire before performing any service.

Oil

Change oil when the engine is warm. Refer to the oil 
specification to select the proper grade of oil for your 
operating environment.
1.  Remove the oil drain plug with a 10 mm socket and 

extension.

2.  Allow the oil to drain completely.
3.  Replace the drain plug.
4.  Remove oil fill cap/dipstick to add oil.
5.  Add 0.6 qt. (0.6 L) of oil and replace oil fill cap/

dipstick. DO NOT OVERFILL.

6.  Dispose of used oil at an approved waste 

management facility.

Spark Plugs

1.  Remove the spark plug cable from the spark plug.
2.  Inspect the electrode on the plug. It must be clean 

and not worn to produce the spark required for 
ignition.

3.  Make certain the spark plug gap is 0.6 - 0.8 mm 

(0.024 - 0.031 in.).

4.  Refer to the spark plug recommendation chart when 

replacing the plug.

5.  Carefully thread the plug into the engine.
6.  Use the spark plug tool to firmly install the plug.
7.  Attach the spark plug wire to the plug.

0.6 - 0.8 mm

(0.024 - 0.031 in.)

Once oil has been added, use the dipstick to check oil 
level, DO NOT screw in the dipstick while checking.

NOTE

FILL

FILL

DIPSTICK