Champion Power Equipment 93520, Owner'S Manual & Operating Instructions

REV 93520-20130425  

14

93520

ENGLISH

OPERATION

Before Each Use Inspect the Log Splitter

1.  Check the hydraulic oil level and visually inspect all 

hoses, attachments and cylinder for loose fittings, 
leaks, cracks, fraying or other damage.

2.  DO NOT operate the log splitter if there is any 

indication of damage.

3.  Inspect the engine and make sure the oil level is 

correct before operating. If the engine is equipped 
with a spark arrestor, clean and inspect it regularly 
(follow spark arrestor maintenance schedule).

4.  The tires need to be fully inflated and in good repair. 

Reference the tire sidewall for recommended tire 
pressure.

Towing Log Splitter Safety

1.  Always check local and state regulations regarding the 

requirements for towing, licensing and lights.

2.  Before towing make sure the log splitter is correctly 

and securely attached to the vehicle and the safety 
chains attached with enough slack to allow for turning.

3.  Support leg must be pinned in the “UP” position for 

towing.

4.  Never exceed the max. travel speed of 45 mph. Towing 

the log splitter at speeds greater than 45 mph could 
result in serious injury or death. Always adjust your 
towing speed according to the terrain and conditions.

5.  Always disconnect the log splitter from the towing 

vehicle before operating.

Log Splitter Location

This log splitter must have at least seven feet of 
clearance from combustible material. Leave at least 
three feet of clearance on all sides of the log splitter to 
allow for adequate cooling, maintenance and servicing. 
DO NOT place the log splitter near vents or intakes 
where engine exhaust fumes could be drawn into 
occupied or confined spaces.

 ONLY operate the log 

splitter outdoors.

DO NOT over inflate tires. Serious injury can result 
if tires explode. 
DO NOT tow the log splitter if the tires are worn or 
will not hold air. 
DO NOT exceed the maximum 45 MPH (72 KPH)
towing speed.

WARNING

Vertical Operating

Position

Work Zone

Horizontal Operating

Position

Wo

rk

Zo

ne

Log Splitter Location Cont’d.

For Vertical Operation:

– Remove the beam lock-pin from the beam 

bracket

– Use handle on cylinder to rotate beam to vertical 

position

– Insert beam lock-pin in the pivot bracket

NOTE

The log splitter needs to be on a dry level surface with 
good footing. DO NOT work on mud, ice, tall grass, 
brush or snow.
Only operate log splitter from work zones shown below.