Champion Power Equipment C75520, User Manual

Assembly 

9

CAUTION 

The engine is equipped with a low-oil-shutoff and 
the will stop when the oil level in the crankcase 
falls below the threshold level. 
 

  NOTE 

Check oil often during the break-in period. Refer 
to the Maintenance section for recommended 
service intervals. 
 

  NOTE 

The generator rotor has a sealed, pre-lubricated 
ball bearing that requires no additional lubrication 
for the life of the bearing. 
 

Connect LPG cylinder 

1.

Turn off the fuel valve.  

2.

Attach the LPG connector to the gas 

inlet. 

3.

Open the manual shutoff valve on the 
LPG cylinder. 

4.

Open the fuel valve on the generator. 

 WARNING 

Liquefied Petroleum Gas is extremely flammable 
and explosive. 

If there is a strong smell of gas: 
Close off the gas supply at the cylinder. 
Use soapy water which will produce a large 
bubble at the point of any leak, to check the 
cylinder valve, connections and the generator. 
Do not smoke or light a cigarette. 
Contact a qualified technician to inspect and 
repair the LPG system. 

 CAUTION 

Use approved LP cylinders equipped with an OPD 
(overfilling prevention device) valve. 

Always keep the cylinder in a vertical position 
with the valve on top and installed at ground 
level on a flat surface 
Cylinders must not be installed near any heat 
source and should not be exposed to sun, rain, 
dust and heat. 
Regulators to be used on the cylinders must be 
of the same diameter as the cylinder valve.  
Regulators should always be in the off position 
when the cylinder is not in use. 

Grounding 

Your generator must be properly connected 
to an appropriate ground to help prevent 

electric shock. 

 WARNING 

Failure to properly ground the generator can 
result in electric shock. 
 

A ground terminal connected to the frame of 

the generator has been provided on the 
power panel. For remote grounding, connect 

of a length of heavy gauge (12 AWG 
minimum) copper wire between the 

generator ground terminal and a copper rod 

driven into the ground. We strongly 
recommend that you consult with a qualified 

electrician to ensure compliance with local 

electrical codes.