Assembly
8
Rev
CSA40037-20080428
Assembly
Your generator requires some assembly.
This unit ships from our factory without oil.
It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the
assembly of your generator, call our help
line at 1-877-338-0999. Please have your
serial number and model number available.
Remove the Generator from
the Shipping Carton
1.
Set the shipping carton on a solid, flat
surface.
2.
Remove everything from the carton
except the generator.
3.
Carefully cut each corner of the box
from top to bottom. Fold each side flat
on the ground to provide a surface area
to install the wheel kit and support leg.
Install the Wheel Kit
CAUTION
The wheel kit is not intended for over-the-road
use.
You will need the following tools to install
the wheel kit:
17 mm wrench OR adjustable
wrench (not included)
Socket wrench with a 16 mm socket
Pliers (not included)
1.
Before adding fuel and oil, tip the
generator on it’s side.
2.
Slide the M10x105 wheel bolt through
the washer, sleeve and wheel.
3.
Slide the bolt through the mount point
on the frame.
4.
Fasten securely with the 10mm nut.
5.
Repeat steps 1-3 to attach the second
wheel.
Install the Support Leg
1.
Attach the rubber vibration mount to
the support leg with a cap screw
(M8x32) and lock nut (M8).
2.
Attach the support leg to the generator
frame with cap screws (M8x16) and lock
nuts (M8).
3.
Tip the generator slowly so that it rests
on the wheels and support leg.
Install the Handle
1.
Place the handle over the mounting
channel on the frame.
2.
Secure the handle to the frame using the
two handle bolts.
3.
Place a lock nut (M8) on the end of each
bolt and fasten securely. DO NOT over
tighten the lock nuts.
Install the Spark Arrester
Insert the spark arrester screen into the
muffler outlet. Secure the spark arrester by
placing the cover plate over the end of the
screen, with the lettering facing outward.
Summary of Contents for CSA40037
Page 2: ......
Page 4: ......
Page 22: ...Specifications 18 Rev CSA40037 20080428 Parts Diagram...
Page 25: ...Specifications Rev CSA40037 20080428 21 Wiring Diagram...
