10
ENGLISH
RT10010
asseMbly
Your chipper-shredder requires some assembly. This unit
ships from our factory without oil. It must be properly
serviced with fuel and oil before operation.
If you have any questions regarding the assembly of your
chipper-shredder, call our help line at +44(0)1942-715-407.
Please have your serial number and model number available.
Unpacking
1. Set the shipping crate on a solid, flat surface
2. Carefully cut the shipping bands and remove lid of
shipping crate.
3. Locate all hardware before beginning assembly.
Install the Wheels & Axle
1. Slide a wheel (12) with valve stem facing out onto the
axle (16) (fig. 1).
Slide the first wheel on the circlip side of the axle
(16).
The circlip on the axle (16) will prevent the wheel
(12) touching the base frame (9).
By tightening the wing bolt on the axle frame (fig. 4)
the axle (16) will be held in position and allow the
wheel nuts to be tightened fully.
Slide the first wheel on the circlip side of the axle
(16).
NOTE
NOTE
NOTE
NOTE
2. To secure, place the wheel washer and nut onto the
axle. Tighten the nut (fig. 2).
3. Slide the axle through the hole in the base frame (9)
and out the other side (fig. 3).
4. Place the second wheel (12) on the protruding end
of the axle (16) and secure in place with the wheel
washer and nut. Tighten the nut.
5. Check and maintain tyre pressure at 20 psi.
Fig.1
Fig.2
Fig.3
Fig.4
