13
RT10010
ENGLISH
EN
Add Oil
Air filter
Adding fuel
1. Be sure to check that the wood chipper is on a level
surface with the engine stopped.
2. Remove the oil filler cap (6), and wipe the
dipstick with a clean rag. Check the oil level by
inserting the dipstick in the filler hole without
screwing it in and then removing it again (fig. 14).
The air filter (13) must always be in perfect
working order, to prevent debris and dust from being
sucked into the engine thus reducing the efficiency and
life of the engine.
– Always keep the air filter (13) free of debris and
in perfect working order.
– If necessary, replace the filter with an original
spare part. Incompatible filtering can impair the
efficiency and life of the engine.
– Never start the engine without the air filter
(13) assembled.
– To change the air filter (13) refer to the
maintenance section of the engine instruction
manual.
The wood chipper is shipped without oil and must be
filled before starting. Engine sump capacity: JRE-
1005:600ml,JRE-1007:1100ml. (Use SAE30 or
10W30 oil).
Only use unleaded 91 RON (Research Octane
Number) petrol. Purchase fuel in quantities that can
be used every 30 days to prevent gum or foaming
inside the container and/or fuel tank.
NOTE
NOTE
3. If the oil level is below the end of the dipstick, refill
(use a funnel, do not tip wood chipper) until it
registers on the halfway mark of the dipstick (fig.
15). Use premium quality 4-stroke engine
oil. Recommended SAE30 or 10W30 for most
climate conditions in Australia.
Fig.14
Fig.15
Using non-detergent oil or 2-stroke engine oil could
shorten the engines service life.
CAUTION
Keep away from cigarettes, smoke and sparks when
refuelling the engine. Always refuel in a
wellventilated location.
WARNING
Be careful not to spill fuel when refuelling.
Spilled fuel or fuel vapour may ignite. If any fuel
is spilled, make sure the area is dry before starting
the engine.
WARNING
Do not over fill the fuel tank.
WARNING
Do not refill tank while engine is running or hot.
WARNING
Pre-oPeratIon cHecK