100806 - 7500W ELEcTRic START GENERATOR
MAiNTENANcE
24
MAiNTENANcE
Make certain that the generator is kept clean and stored properly.
Only operate the unit on a flat, level surface in a clean, dry
operating environment. DO NOT expose the unit to extreme
conditions, excessive dust, dirt, moisture or corrosive vapors.
WARNiNG
Never operate a damaged or defective generator.
WARNiNG
Improper maintenance will void your warranty.
NOTicE
For Emissions control devices and systems, read and
understand your responsibilities for service as stated in the
Honda Engine Emission Control Warranty Statement of the
owner/operator’s manual.
The owner/operator is responsible for all periodic maintenance.
Complete all scheduled maintenance in a timely manner.
Correct any issue before operating the generator.
For service or parts assistance, contact our
Technical Support Team at 1-877-338-0999.
For engine maintenance, refer to Honda’s engine owner/operator
manual.
cleaning the Generator
cAUTiON
DO NOT spray generator directly with water.
Water can enter the generator through the cooling slots and
damage the generator windings. It can also contaminate the
fuel system.
1. Use a damp cloth to clean exterior surfaces of the generator.
2. Use a soft bristle brush to remove dirt and oil.
3. Use an air compressor (25 PSI) to clear dirt and debris from
the generator.
4. Inspect all air vents and cooling slots to ensure that they are
clean and unobstructed.
To prevent accidental starting, remove and ground the spark plug
wire before performing any service.
changing the Engine Oil
Refer to Honda’s engine owner/operator manual.
cleaning and Adjusting the Spark Plug(s)
Refer to Honda’s engine owner/operator manual.
cleaning the Air filter
Refer to Honda’s engine owner/operator manual.
cleaning the Spark Arrestor
1. Allow the engine to cool completely before servicing the spark
arrestor.
2. Remove the 4 screws holding the cover plate which retains
the spark arrestor to the muffler.
3. Remove the spark arrestor screen.
4. Carefully remove the carbon deposits from the spark arrestor
screen with a wire brush.
5. Replace the spark arrestor if it is damaged.
6. Position the spark arrestor on the muffler and attach with the
screws removed in step 2.
cAUTiON
Failure to clean the spark arrestor will result in poor engine
performance.
Adjusting the Governor
Refer to Honda’s engine owner/operator manual.
