28
100883 - 27 TON LOg SPLiTTER
STORAgE
EVERY YEaR
Inspect wheel bearings and repack bearing grease as
needed.
EVERY 3 YEaRS
Replace fuel line*
* To be performed by knowledgeable, experienced owners or CPE certified service
centers.
STORAgE
Refer to the
Maintenance
section for proper cleaning instructions.
Log Splitter Storage
1. The log splitter needs to be cool for at least 5 minutes before
storing.
2. Clean the log splitter before storage according to the
Maintenance section.
3. Retract the wedge to protect the rod from corrosion.
4. Wipe the beam and wedge with an oily rag to prevent rust
and corrosion.
Engine Stored for Less than 30 Days
1. Allow the engine to cool completely before storage.
2. Clean engine according to the
Maintenance
section.
3. To extend the fuel storage life add a properly formulated fuel
stabilizer to the tank.
4. Ensure the fuel valve is in the “OFF” position.
Engines Stored for Over 30 Days
1. Add a properly formulated fuel stabilizer to the tank.
2. Run the engine for a few minutes so the treated fuel cycles
through the fuel system and carburetor.
3. Turn the fuel valve to the “OFF” position.
4. Let the engine run until fuel starvation has stopped the
engine. This usually takes a few minutes.
5. The engine needs to cool completely before cleaning and
storage.
6. Clean the engine according to the
Maintenance
section.
7. Change the oil.
8. Remove the spark plug and pour about 14.8 mL (
1
⁄
2
ounce) of
oil into the cylinder. Using the Recoil, crank the engine slowly
to distribute the oil and lubricate the cylinder.
9. Reattach the spark plug.
WARNiNg
Never store the log splitter indoors next to appliances where
there is a source of heat or open flame, spark or pilot light
because they can ignite gasoline vapors. Even with an empty
gas tank, gasoline vapors could ignite.
DO NOT store a log splitter near fertilizer or any corrosive
material.
