(23)
OM000PI PI Manual REV 5 080119
REMOVING/INSTALLING SEAT
1.
Place the chair into the full recline position.
WARNING: Before moving the chair, unplug the chair from the wall outlet and
make sure to keep clear of all moving parts. Pinch points can be created while the
chair is in motion.
2.
Locate and remove the 2 yellow thumb knobs under the left and right edge of the
seat front.
3.
Once clear from all moving parts, return the chair to the full upright position. Grab
the lower front edge of the seat and lift the front of the seat until the stud clears
the mechanism.
CAUTION: Heat or heat/massage components are fixed to the underside of the
removable seat cushion. The seat can be slid forward BUT must be flipped up and
placed in the chair. This allows the seat to be moved for access to the inside of your
recliner without having to remove any components.
4.
Slide the seat outward until it is free of the mechanism. Once it is free of the
mechanism tip it back against the chair back.
Installing the Seat:
1.
With the chair in the full upright position, place the quick release seat clips under
the flange on both sides of the mechanism, slide the seat back in the chair.
2.
When the bolts reach the flange, lift up on the front of the seat and slide it back
until the bolts drop into the holes in the mechanism. Move the chair into the full
recline position and thread on the yellow thumb knobs to secure the seat in place,
making sure the stem on the knob is facing up. Return the chair to full upright
position before having an occupant enter the chair.
NOTE: The swing arms may be opened in the upright position to allow access to the
thumb-knobs that secure the quick release seat to the mechanism.
