Champion ®
Makadamgatan 14 I 254 64 Helsingborg I Sweden
info@championnordic.se
Designed in Sweden I Assembled in China
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
Specifikations
Model Number:
CHPM310
Net Weight:
4,2kg
Voltage: AC220V-240V
Frequency:
50Hz-60Hz
Power:
180W
Trouble shooting
Problem
Analysis
Trouble shooting
Power connected.
Power button pressed.
The product does not operate.
1. The plug has not been fully
inserted.
2. Due to extended operation,
the machine has been automa-
tically shut down for protection.
1. Make sure the power is pro
-
perly connected.
2. Restart the machine after 20-
30 minutes.
During the first few operations,
a smell emanates from the
machine.
This is a normal phenomenon
for new motors.
If the smell persists after few
uses, contact customer service
center.
Abnormal vibration and noise.
1. The extrusion rod is not in
-
stalled correctly.
2. The noodle mold is installed
oppositely.
3. The locker is not screwed on
well.
Check the extrusion rod, noodle
mold, locker and re-install them.
“Creak” noise when the machi
-
ne is in operation.
The plastic seal inside the
kneading chamber is not
smooth enough.
Add a drop of edible oil
to the plastic sel.
The control panel displays: ”E0” 1. The dough is too dry.
2. Too much dough
1. Put the dough again into the
kneading chamber, add an ade-
quate amount of water.
2. Reduce part of dough to
re-operate.
EN
7