Champion CHWH100, Manual

Charging

1) Place the headset in the charging station and connect it to a power source with the USB C 

    cable (included) 

2) The red LED light is on during charging and turns off when the headset is fully charged. 

3) Disconnect the USB C cable when the headset is fully charged. The speaker will indicate 

     "low battery" when the battery level is low.

Bluetooth

1. Make sure your headset and your Bluetooth device are near to each other (no more than 

    1m apart). 

2. Press and hold the switch for 5 seconds to start the pairing mode for the headset. The 

    Bluetooth indicator will flash blue and red. 

3. Enable Bluetooth on your device and search for nearby Bluetooth connections. 

4. Find "CHWH100" in the search results.Click the name to connect your device. When 

    connected the LED indicator will slowly flash blue.

5. Reconnect: After succesfully pairing your device, press and hold the "On button" for 3 

    seconds to start and reconnect the headset.

If you want to pair a new device, press and hold the On/Off button for about 5 seconds to enter 

the pairing mode. The headset turns off after 10 minutes when not in use.