Waste Handling Precautions
1. The waste handling system is designed to process a wide range of waste products that
are water soluble including: food waste, paper (e.g., paper napkins, cardboard).
2. The system will process waxed paper in limited amounts but only if the waxed paper is
loaded in conjunction with waste products described above.
3. DO NOT FEED THE FOLLOWING MATERIALS INTO THE PULPER:
4. Metal (e.g., box staples, metal foil, steel wool, metal fasteners, wire, coins, and metal
utensils
5. Styrofoam
6. Plastic spoons, forks, knives, cups, plates, or bowls
7. Condiment packages (e.g., ketchup, mustard, etc.)
8.
Plastic bottles/bottle caps
CAUTION:
Damage to the waste handling system will result
if metal objects are fed into the machine. This
includes, but is not limited to, box staples, metal
foil, steel wool, metal fasteners, wire, coins, and
metal utensils
WHEN IN DOUBT— KEEP IT OUT.
WARNING!
The Remote Waste Handling System contains
ROTATING PARTS moving at high speed.
Death or serious injury may result if clothing, jewelry, or
body are caught in the machine.
NEVER run the machine unless all safety devices are in good working
condition and all safety covers are installed on the machine.
Waste Handling Precautions
6
Summary of Contents for P5-24
