TIMER
The timer unit consists of 4 buttons, two lights (red and green) and a display .
P+M button Press once for Manual mode (green light) display shows ‘MANU’
Press a second time for Preset timer mode (red light) display shows ‘TIMER’ Press for a third time
to turn off (both lights OFF)
T button When in ‘TIMER’ mode use the ‘T’ button to increase the selected operating time up to a
maximum of 15 minutes.
S button When in ‘TIMER’ mode, and after selecting a time using the ‘T’ button, press the ‘S’
button to turn the Facial Sauna on, the red light will come on and Facial Sauna will run for the
time selected. At the end of this time the red light will flash and a buzzer will sound and then the
unit will turn off.
We recommend you set the timer function after the Facial Sauna has warmed up and started to
produce steam.
CLEANING
Ensure the Facial Sauna is disconnected from the mains supply and has cooled down after
use. Remove any attachments, drain any excess water from the evaporation pan and clean the
outside case using a damp, not wet, cloth and dry before further use.
DO NOT immerse in water.
DO NOT use petroleum based or flammable cleaning agents because of fire risk.
DO NOT use abrasive cleaning agents.
CAUTION: To prevent damage completely remove any mineral or fatty residue after each use,
removal of stubborn lime scale may require a commercial de-scaling agent which is suitable for
use on stainless steel.
WIRING
The mains lead of this appliance is fitted with a (BS1363) plug fitted with a 3A fuse. If it ever
becomes necessary to replace the fuse only use a fuse of the same rated value and which is
approved to BS 1362. If in doubt contact a qualified electrician.
