6
RS660-101022
Link
Provision has been made for stereo linking of two RS660
Compressors, by means of the female ¼”
LINK
connector
located on the rear of the unit, and using a standard ¼” ca-
ble. For further notes on operation under linked conditions,
review the “Link” section within the “Controls and Instru-
ments” chapter of this manual.
Note:
Link cable purchased separately.
Audio Interconnections
On the rear panel of the RS660 Compressor exists two XLR
jacks (wired pin 2 hot), one for
INPUT
, and the other for
OUTPUT
. Both input and output connections are +4, trans-
former balanced.
Note:
Input impedance
is 15k ohms.
LINK - USE STANDARD 1/4” TIP - SLEEVE CABLE
CV
0v
OUTPUT
LINK
TIP- CV
SLEEVE- 0v
OUTPUT IMPEDANCE
200
600
INPUT
OUTPUT IMPEDANCE
200
600
Chandler Limited
RS660
000001
OUTPUT
MAINS VOLTAGE
110-120V
220-240V
LINK
TIP- CV
SLEEVE- 0v
E M I L TD
.
. .
E
R
S
P
M
O
R
S O
C
R
T
0
Y P E
S
6
6
