Changhong Electric FS209R02W, User Manual

3

R600A WARNINGS

NOTE: This model uses 0.087Kg of R600A flammable refrigerant in its sealed system.  
The following must be observed for your safety:  

 
   R600A Refrigerant Warning

• This appliance contains a small quantity of R600A refrigerant which is 

environmentally friendly, but flammable. It does not damage the ozone 
layer, nor does it increase the greenhouse effect. 

• During transportation and installation, ensure that the tubing of the refrigerant 

circuit is not damaged. 

• Leaking refrigerant can ignite and may damage the eyes. 
• In the event any damage does occur, avoid exposure to open fires and any 

device which creates a spark. Disconnect the appliance from the mains 
power. 

• Thoroughly ventilate the room in which the appliance is located for several 

minutes. 

• Notify Customer Service for necessary action and advice. 
• The room for installing the appliance must be at least 1 cubic metre per 8 

grams of refrigerant. The refrigerant quantity contained in this appliance is 
listed above in grams; it is also noted on the Rating Plate of the appliance. 

It is hazardous for anyone other than an Authorised Service Person to carry out 
servicing or repairs to this appliance. In Queensland the authorized person must 
hold a Gas Work Authorisation for hydrocarbon refrigerants, before carrying out 
servicing or repairs which involve the removal of covers. 

INSTALLATION INSTRUCTIONS 

Transportation and Handing

When moving the unit, always hold the base, and lift carefully while keeping  
the unit upright.  The unit should never be tilted beyond 45 degrees, placed upside 
down, or laid on its side, back, or front.  Never hold onto the door for support while 
moving the unit.  It may damage the hinges. 
 

Installation 

1. Place the freezer on a flat, firm surface.  This will help eliminate noise caused by 

vibration. 

2. Choose a ventilated area.  There should be at least 10 cm of open space along the 

sides, top, and back of the freezer. 

3. Select a location which is away from heating sources, direct sunlight, ovens, etc.  

Also, the area should be dry, and free of damp, stale air. 

Testing 

1. Clean the freezer with lukewarm water and detergent, and wipe dry.  

Note: 

Electrical components should be cleaned with a dry cloth. 

2. Turn the thermostat knob to the “2” position, and plug the freezer into the wall 

outlet. The compressor will begin to run. 

3. Check, after 30 minutes of operation, to ensure that the freezer is cold.