Basic Operation
• Turn on the TV
Connect the TV to your mains socket.
If TV has a power switch, turn it on firstly. In standby mode, press Power button on
the remote to turn on the TV.
• Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your TV in standby mode for long periods of time. It is best to unplug the
power cord.
NOTE:
If there is an accident power off, the TV will be in standby mode automatically after
re-supply the power. To ensure the normal use of the TV, the frequent turning on and
off is forbidden, when there is an accident power off, it is recommended to unplug the
power cable from the power socket.
• No signal
When the TV is working in RF receiving mode, the TV will enter standby mode
automatically 10 minutes after there is no any signal (such as the programs are
stopped by TV station). In PC mode, the TV set will automatically turn off in 90
seconds if no signal. When VGA cable is connected, the TV turns on automatically.
If this is the first time you run the TV, the Initial Setup Menu will appear in the picture,
and the items of this menu also exist in other menus, so you are able to change the
values after you set them up.
Tips:
Make sure that the antenna connection is made.
■
Set you desired language
Press ◄/
►
buttons to select the language to be used for menus and message.
■
Set you desired Country
Press◄/
►
buttons to select the country you want to.
■
Tuning Setup
Turning on and off the TV
Tune Type: Press the◄/
►
buttons to select: DTV+ATV, DTV, ATV.
Digital Type: DVB-T.
Start: Press the
ENTER
button to start the auto searching.
■
Select your TV Environment.
E
ngli
sh
Signal Type is DVB-T:
First Time Installation
Press◄/
►
buttons to select the store mode or home mode.
12
