E
nglish
Connection and Setup
Connection Installation
antenna signals or closed circuit TV signals.
DVD player, digital TV set, etc.).HDMI is also called as high definition multimedia
interface, and it can transmit digital audio and video signal with one cable.
NOTE:
While connecting the HDMI, please aim at carefully, do not insert overexertedly,
for fear the pin
might be broken.
equipment via the Digital Audio Output port.
the TV through AV cable.
connected with the COMPONENT(YPbPr) input port of the TV through AV cable.
NOTE:
Both Audio signals of AV and COMPONENT are input from "R - Audio - L".
If COMPONENT (YPbPr) and AV works as mini terminal, and shared same audio,
Please choose to use a one-to-three audio &video cable.
:
Connect it to your headphone or other audio equipment.
NOTE:
The range of power input for the TV is 100-240V~ 50/60Hz; Do not connect the
TV power input port with the power cable out of the above range.
other end of the VGA cable with the VGA port on the TV, and tighten the bolts
clockwise on the each end of VGA cable.
NOTE:
While connecting the 15-pin VGA, please do not insert the plug overexerted, for
fear the pin might be broken.
jacks.
7
1. PC:
Connect one end of the VGA cable with the VGA port on computer, connect the
2. SCART:
Connect SCART socket input or output from an external device to these
3. ANT(1,2):
Used to connect the antenna or the cable TV network, and receive outdoor
4. HDMI(1,2,3):
Support AV devices with an HDMI connector (such as set top box,
5. DIGITAL AUDIO OUT:
Sending the TV's digital audio signal to external audio
6.
AV IN:
The output AV terminal of DVD can be connected with the AV input port of
7. COMPONENT(YPbPr):
The output COMPONENT(YPbPr) terminal of DVD can be
8. CI:
Please insert CI card into the PCMCIA slot according to the arrow on the CI card.
9. USB:
USB port,
used to connect USB devices, such as USB Disk.
10.
11.
Connect the power cable with 100-240V~ power supply.
